Medtronic MiniLink Manuel D'utilisation page 6

1 Insert the MiniLink into the charger by
lining up the MiniLink connector (flat
side down) with the charger. Push the
two components together fully.
2 Within 10 seconds after the MiniLink is
connected, a green light on the charger
will flash for 1-2 seconds as the charger
powers on. For the rest of the charging
time, the charger's green light will flash
on and off every second.
3 When charging is complete, the green
light on the charger will stay on, without
flashing, for 15-20 seconds and then turn off.
4 After the green charger light turns off,
disconnect the MiniLink from the charger. The
green light on the MiniLink will flash for about 5
seconds and then turn off. Your MiniLink is now
ready to use. See the picture on the right.
Setting up the MiniLink
The serial number is on the flat side of the
transmitter, as shown on the right. See your
monitor user guide for steps on entering this
number.
Connecting to the sensor
The MiniLink must be fully charged before
connecting it to the sensor.
1 After the sensor is inserted (follow the instructions provided with
your sensor), wait 5 minutes before connecting the transmitter.
Check for bleeding. Make sure that bleeding has stopped (see
Warnings page for details), then connect the MiniLink to the
sensor.
2 Touch the inserted sensor at back of assembly to prevent
movement.
green light
SN GT2XXXXXXM
- 5 -
MEDTRONIC MINIMED
MiniLink Transmitter
REF MMT-7703XX
SN GT2XXXXXXM
FCC D: OH27703
IPX8
IC: 3458-7703
1234