Charging The Battery; Operation; Preparing For Use - Hilti TE 4-A18 Mode D'emploi

6.2 Charging the battery

en
DANGER
Use only the Hilti batteries and Hilti chargers listed
under "Accessories".
6.2.1 Charging a new battery for the first time
Charge the battery fully before using it for the first time.
6.2.2 Charging a previously used battery
Ensure that the outer surfaces of the battery are clean
and dry before inserting it in the corresponding charger.
For information about the charging process, read the
operating instructions for the charger and section 2.10
Charge status of the Li-ion battery in these operating
instructions.
Li-ion batteries are ready for use at any time, even when
only partly charged. Charging progress is indicated by
the LED display (see charger operating instructions).
6.3 Fitting the battery 2
CAUTION
Before fitting the battery, check that the power tool
is switched off and that the safety lock is engaged
(forward/reverse switch in the middle position). Use
only the Hilti batteries approved for use with this
power tool.
1. Push the battery into the power tool from the rear
until it is heard to engage with a double click.

7 Operation

CAUTION
In the event of the drill bit sticking, the power tool will
pivot about its own axis. Always use the power tool with
the side handle fitted and hold it securely with both hands
so that the resulting opposing force causes the slip clutch
to release in the event of the drill bit sticking. Use clamps
or a vice to hold the workpiece securely.

7.1 Preparing for use

7.1.1 Fitting the insert tool 5
CAUTION
Wear protective gloves when changing the insert tool.
8
CAUTION A falling battery may present a risk of
2.
injury to yourself or others.
Check that the battery is seated securely in the
power tool.
6.4 Removing the battery 3
1. Press both battery release buttons.
2. Pull the battery out of the power tool toward the
rear.
6.5 Transport and storage of battery packs
Pull the battery pack out of the locked position (working
position) and move it into the first click-stop position
(transport position).
If you disconnect a battery pack from the power tool
for transport or storage, make sure that the contacts of
the battery pack are not short-circuited. Remove loose
metal parts such as screws, nails, clamps, loose screw
bits, wires or metal swarf from the case, toolbox or
transport container, or prevent these parts from coming
into contact with the battery packs.
Observe national and international transport regulations
when shipping battery packs (transportation by road, rail,
sea or air).
6.6 Fitting the side handle 4
1. Set the forward / reverse switch to the middle posi-
tion or remove the battery from the power tool.
2. Release the side handle clamping band by turning
the handle counterclockwise.
3. Remove the depth gauge from the side handle in
order to avoid injury.
4. Slide the side handle clamping band over the chuck
and onto the shaft.
5. Pivot the side handle into the desired position.
6. Fit the depth gauge and secure the side handle in
the desired position by turning the grip firmly until
tight.
1. Set the forward / reverse switch to the middle posi-
tion or remove the battery from the power tool.
2. Check that the connection end of the insert tool is
clean and lightly greased. Clean it and grease it if
necessary.
3. Check that the sealing lip of the dust shield is clean
and in good condition. Clean the dust shield if nec-
essary or replace it if the sealing lip is found to
be damaged (please refer to the "Care and mainte-
nance" section).
4. Push the insert tool into the chuck and rotate it while
applying slight pressure until it engages in the guide
grooves.
5. Push the insert tool into the chuck until it is heard to
engage.
6. Check that the insert tool has engaged correctly by
pulling it.