Safety Instructions; General Description - Eneo EDC-IPS-2/24V Mode D'installation

1. Safety Instructions

• Read these safety instructions and the operation manual first before you install and commission the camera.
• Keep the manual in a safe place for later reference.
• Contact your local dealer in case of malfunction.
• Protect your camera from contamination with water and humidity to prevent it from permanent damage. Never switch the camera on when it gets wet.
Have it checked at an authorized service center in this case.
• Do not operate the cameras beyond their specified temperature, humidity or power ratings.
• Operate the camera only at a temperature range of -0°C to +50°C and at a humidity of max. 90%.
• To disconnect the power cord of the unit, pull it out by the plug. Never pull the cord itself.
• Pay attention when laying the connection cable and observe that the cable is not subject to heavy loads, kinks, or damage and no moisture can get in.
Do not attempt to disassemble the camera board from the dome.
• The warranty becomes void if repairs are undertaken by unauthorized persons.
• Only use original parts and original accessories from Videor E. Hartig GmbH.
• Use a dry cloth to clean the dome surface. In case the dirt is hard to remove, use a mild detergent and wipe gently.
NOTE: This is a class A digital device. This digital device can cause harmful interference in a residential area;
in this case the user may be required to take appropriate corrective action at his/her own expense.

2. General Description

Indoor housing for Fastrax III Series wall and ceiling mounted cameras
• Standard version with fan and heater
• Housing with tinted bubble: 6,5" (65mm), Art. No. 7434
• Housing with clear bubble: 6,5" (65mm), Art. No. 7435
• Protection class: IP66
Accessories pack: 3x screws M4x8
x Allen key 5mm for bubble ring
Outdoor housing for cameras of the Fastrax III series for wall and ceiling mounting
• Standard version with heater, fan and sunshield
• Housing with tinted bubble: 6,5" (65mm), Art. No. 7430
• Housing with clear bubble: 6,5" (65mm), Art. No. 7436
• Protection class: IP66
Accessories pack: 3x screws M4x8
x Allen key 5mm for bubble ring
Flush mount dome housing for mounting of dome cameras in suspended ceilings, Art. No. 74154
• For in-ceiling installation of dome cameras of the Fastrax III series I to III
• Tinted bubble: 6.8" (7mm)
Accessories pack: x safety ring string (wire)
x screws, self-tapping (M4, mm long)
x screw, self-tapping (M4, mm long)
9