Safety Instructions / Maintenance; General Description - Eneo EDC-AKS1 Mode D'emploi

1. Safety Instructions / Maintenance

• Read these safety instructions and the operation manual first before you install and commission the unit.
• Keep the manual in a safe place for later reference.
• The system may only be commissioned and maintained by personnel authorized to do this and it must only be
carried out in accordance with relevant standards and guidelines.
• Never cover the ventilation slots to avoid overheating.
• Never insert metal objects or any other items into the vents. This may permanently damage the unit.
• P rotect your unit from contamination with water and humidity to prevent it from permanent damage. Never switch
the unit on when it gets wet. Have it checked at an authorized service center in this case.
• Never operate the units outside of the specifications as this may prevent their functioning.
• D o not operate the unit beyond their specified temperature, humidity or power ratings. Operate the unit only at a
temperature range of –40°C to +50°C and at a humidity of max. 90%.
• The unit should be protected against excessive heat, dust, damp and vibration.
• Do not place any heavy objects on the unit.
• To disconnect the power cord of the unit, pull it out by the plug. Never pull the cord itself.
• P ay attention when laying the connection cable and observe that the cable is not subject to heavy loads, kinks, or
damage and no moisture can get in.
Do not attempt to disassemble the camera board from the dome.
• Contact your local dealer in case of malfunction.
• The warranty becomes void if repairs are undertaken by unauthorized persons. Do not open the housing.
• Maintenance and repair have to be carried out only by authorized service centers. Before opening the cover
disconnect the unit from mains input.
• Only use original parts and original accessories from Videor E. Hartig GmbH.
• D o not use strong or abrasive detergents when cleaning the dome. Use a dry cloth to clean the dome surface.
In case the dirt is hard to remove, use a mild detergent and wipe gently.

2. General Description

• Power & Connection for EDC Dome Camera Housings (# 74125)
Power & Connection for NTD-6xx in Dome Housings (# 74145)
• Input Voltage: 30VAC
• Output Voltage: 4VAC/3.0A (# 74125)
VDC/4VAC (# 74145)
• Signal/Data and Alarm Loop-tru Terminals Inside
• Weatherproof Die-cast Aluminium Wall Mount Box
• Box includes Turnable Bracket Arm
• Protection Rating: IP66
4