Cavist 8 Manuel D'utilisation page 6

OPERATION OF WINE COOLER
Initial Setup
Locate the wine cooler according to the installation limitations. Once you have plugged the unit
into an electrical outlet, let the unit run for at least 30 minutes before making any adjustments.
Temperature Adjustments
a) Your wine cooler has an electric temperature control on the front of the units. You can set
the temperature of your wine cooler at any setting your desire. The temperature will range
from 8 degree to 18 degree. When initially turned on, the LED will display the ambient
temperature and then the internal cabinet temperature.
b) Pressing the ▲ TEMP button on the display will increase the temperature and pressing the
▼ TEMP button will lower the temperature.
c) After you set your desired temperature, the set temperature numerals will flash for 5
seconds and then revert to the internal cabinet temperature.
d) Your wine cellar also has a light for your viewing convenience. A light switch
control panel will activate the light manually. Under normal operation, it is best for the light
to remain off.
e) By pressing the C/F button you can have the temperature readout either in Celsius or
Fahrenheit.
PARTICULAR PRECAUTIONS
• To assure your wine cooler works at the maximum efficiency it was designed for, you
should install it in a location where there is proper air circulation, plumbing and electrical
connections.
• The following are recommended clearances around the wine cooler:
o sides 3/4＂ 19mm
o top 4＂
o back 2＂
• For proper internal air circulation, do not overfill your wine cooler.
• Avoiding direct sunshine temperature.
• Do not place heavy articles on the top of the cellar.
100mm
50mm
on the