nVent RAYCHEM NGC-UIT-ORD Manuel D'installation page 3

INDOOR AND OUTDOOR USER INTERFACE TERMINAL FOR NVENT RAYCHEM NGC SYSTEMS
In case an instruction or information applies to both the
NGC-UIT-ORD and the NGC-UIT-OUT the User Interface will
be called NGC-UIT without the extention -ORD or -OUT
General
Supply voltage 100 – 240 VAC ±10%, .25 A max/25 VA,
50/60 Hz
Operating temperature –40°C to 65° (–40°F to 149°F)
EMC Immunity – Industrial
Emission – Commercial / Light Industrial
Vibration Unit tested to IEC-60068-2-6
Shock Unit tested to IEC-60068-2-27
Dimensions 260 mm wide X 168 mm high X 76 mm deep
(10 1/4" wide X 6 5/8" high X 3" deep)
Control Outputs
Relay outputs Three relay outputs, SPDT contacts,
switching loads up to 277 VAC/3 A
Relays may be assigned for alarm outputs
11 position Phoenix-style pluggable screw
terminal connector with retaining screws
Network Connection
Local port/ remote RS-485/RS-232, selectable. Port may be used
to communicate with Supervisor Software
RS-232 is non-isolated, RJ-11 connection
RS-485, 2-wire Isolated. Phoenix-style
pluggable screw terminal connector with
retaining screws. Maximum number of
devices 256. Fail safe design with optional
termination resistors
Data Rate to 2400 to 57600 baud
Maximum cable length for RS-485 not to
exceed 1200 m (4000 feet). Cable to be
shielded twisted pair
This component is an electrical device which
must be installed correctly to ensure proper
operation and to prevent shock or fire. Read
these important warnings and carefully follow
all the installation instructions.
NGC-UIT-ORD kit shown
installed in user's panel
• Component approvals and performance are
based on the use of specified parts only. Do
not use substitute parts.
Installation Instructions
Description
The nVent RAYCHEM NGC-UIT-ORD and nVent RAYCHEM
NGC-UIT-OUT are panel mounted displays used in conjunction with
other approved nVent RAYCHEM control and monitoring devices.
The NGC-UIT-ORD is rated IP 54 (NEMA 12), however, the display can
best be viewed indoors or when protected from direct sunlight.
The NGC-UIT-OUT is rated IP 56 (NEMA 4X) and the display can be
viewed outdoors or indoors. The NGC-UIT kits include all hardware
required for mounting in a suitable electrical panel. These
instructions describe how to mount the NGC-UIT in an electrical
panel and are intended only for personnel experienced in panel
construction.
Tools Required
• Masking tape
• 11/32 inch nut driver
• Metal file
Approvals/Certifications
Hazardous Locations
Class 1, Div. 2,
Groups A, B, C, D, T4
LR67275
Class 1, Zone 2
163617
Groups IIC, T4
(Russia, Kazakhstan, Belarus)
For other countries contact your local nVent representative.
Field port RS-485 2-wire isolated. Used to
communicate with external nVent RAYCHEM
devices, such as NGC-30-CRM, MONI-RMC
and RMM2. Maximum cable length not
to exceed 1200 m (4000 ft). Cable to be
shielded twisted pair
Phoenix style pluggable screw terminal
connector with retaining screws. Maximum
number of devices 256. Fail safe design with
optional termination resistors
Data rate to 9600 baud
LAN 10/100 Base-T Ethernet port with Link and
Activity Status LEDs
USB port USB 2.0 Host port Type A receptacle
Status LEDs
Relay Three LEDs showing the ON/OFF Status
for each relay, LED ON indicates relay is
energized
Field Transmit and Receive activity
Local/Remote Transmit and Receive activity
USB host Three colors showing status:
Green = USB key inserted
Red = USB key fault
Yellow = USB in use
UIT status Three colors showing system status:
Green = Normal Condition
Red = Fault Condition
Yellow = loading software/configuration
LCD Display
Display LCD is a 16.6 cm (6.5 inch) QVGA, color
TFT transflective device with integral
CCFL backlight. (For use indoors or when
protected from direct sunlight)
Touch screen 4-wire resistive touch screen interface for
user entry. Usable with gloved fingers
• #16 (3/16) drill bit
• Jig saw (recommend using
carbon steel blade with 24 TPI)
Nonhazardous Locations
73/23/EEC: Low Voltage Directive
including amendments
89/336/EEC: Electromagnetic Compatibility
Directive including amendments
nVent.com | 3