Amplicomms RingFlash 100 Mode D'emploi page 30

Starting Up
In some cases where the amplicomms
Ring Flash is used in conjunction with
older phones or those phones that do
not comply to European Standard ES
203021 connectivity, either the RingFlash
or telephone may not function correctly.
If this happens you may notice the Ring
possible to hear dial tone in the receiver
when the telephone handset is lifted. To
resolve this please retain your existing
telephone line cord with your phone and
use a double adaptor in the telephone
socket (not supplied). Plug the telephone
into one side of the double adaptor then
plug your Ring Flash into the other avail-
able socket on the adaptor.
30
Connecting the doorbell unit
(RingFlash 200 only)
Remove the 4 screws from the back
of the Doorbell.
The Doorbell has a default setting
of Bell 1, if you wish to change this
to Bell 2, please move the switches
inside the Doorbell to the positions
indicated below.
The stop indicator button on
ON
the RingFlash unit will be red
when the Doorbell is pressed.
1 2
Bell 1
The stop indicator button on
ON
the RingFlash unit will be
green when the Doorbell is
1 2
pressed.
Bell 2
Insert the 12 Volt battery supplied,
taking note to position the battery
the correct way around. Replace the
back cover, position and tighten the 4
screws.