Drain Hose Kit: Fitting Instructions - Hoover DYC 88132XB Manuel D'instructions

To avoid emptying the water container after
each drying cycle, the water can be
discharged directly to a waste water drain pipe
(the same drainage system as household
sinks). Water Bye-Laws prohibit connection to
a surface water drain. The waste water drain
pipe should be located adjacent to the tumble
dryer.
The kit consists of:1 hose and 1 tap.
WARNING! Switch off and remove the
tumble dryer plug from the electricity supply
before carrying out any work.
Fit the Hose as Follows:
1.Tilt the machine
backwards.
2. Remove the bottom
protector panel, by
pulling carefully to the
left side.
3. The waste water
pipe is situated at the
right-hand side of the
machine (see the
picture). A grey hose
connects to the bridge
at the left hand side of
the machine. Using
pliers, remove the pipe
retaining clip from the
bridge.
4. Pull the hose off the
bridge connection.
5. Attach the black
hose from the kit,
(using the connector
a n d p i p e c l i p s
supplied), to the hose
removed from the
bridge connection.
EN 6
DRAIN HOSE : FITTING INSTRUCTIONS
6 . P l a c e t h e t a p
supplied by the kit to
close the remaing
hose.
7. Feed the drain hose
through the hole in the
b o t t o m p r o t e c t o r
panel.
8. Carefully slide the
bottom protector panel
back into position
ensuring that the hose
is not trapped.
9. Once the machine is
in place the feet should
be adjusted to ensure
that the new hose does
not kink when pushing
the tumble dryer into
position.
10. Connect the new
drain hose to the waste
Water pipe.
11. Connect to the
m a i n s e l e c t r i c i t y
supply.