Perel EDB6 Mode D'emploi page 11

8.1 Using the Receiver with a Single Transmitter
1. Power both the transmitter and receiver (see above).
2. Press the button once on the transmitter. The receiver will
automatically learn and memorize the code.
3. The transmitter and receiver are ready-for-use.
8.2 Using the Receiver with a Multiple Transmitters
1. Pair the first transmitter to the receiver as explained above.
2. Next, press the auto-learning button once on the receiver.
3. Press the button once on the second transmitter. The receiver
will automatically learn and memorize the code.
4. Operate in the same way for all subsequent transmitters.
Remark:
 The receiver can be paired to a maximum of five transmitters.
8.3 Code Interference
In case of code interference, please proceed as follows:
1. Disconnect the power supply to the receiver and wait for 30
seconds.
2. Reconnect the power supply and restart the learning procedure.
9. Cleaning and Maintenance
The doorbell does not need any particular maintenance. However, it
is advisable to clean it occasionally to keep it looking like new.
10. Troubleshooting
If the receiver does not chime, please check the following:
 Flat batteries in the transmitter. Replace the batteries.
 Make sure the receiver is well connected to the power supply.
 Check the battery polarity in the transmitter.
 Units are out of range. Lessen the distance between transmitter
and receiver.
V. 02 – 26/01/2016
EDB6
11 ©Velleman nv