Cleaning The Device And Accessories; Troubleshooting - MAAX Z 07134 Mode D'emploi

Masquer les pouces Voir aussi pour Z 07134:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
8. Loosen the protective cap for the water reservoir and remove it. Empty the water
reservoir and place it back into the device. Place the protective cap back in position.
You can now continue cleaning.
9. After the cleaning, switch off the device by pressing the On/Off button.
10. Empty and clean the water reservoir each time after you use the device (see
below) to prevent deposits in the reservoir and thus damage to the device!
After Use / Cleaning the Device and Accessories
CAUTION!
Empty and clean the water reservoir each time after you use the device to prevent
deposits in the reservoir and thus damage to the device!
Never immerse the device in water or other liquids!
Do not use any caustic or abrasive cleaning agents or cleaning pads to clean the
device. These can damage the surface.
1. Detach the cleaning attachment with the scraper lip from the main device by pres-
sing the release switch (2) and pulling the attachment off in an upward direction.
2. Clean the attachment with the scraper lip under cold running water.
3. Empty and clean the water reservoir:
– Release the protective cap for the water reservoir.
– Remove the water reservoir and
– allow all of the water from the reservoir to fl ow into a sink.
4. If necessary, wipe down the outside of the device with a soft, slightly damp cloth and
dry it with a soft cloth.
5. Allow all parts of the device and accessories to dry completely before you put the
device away into
6. Store the device in a cool, dry indoor room out of the reach of children and animals.

Troubleshooting

If the device stops working properly, fi rst check whether you are able to correct the
problem yourself.
Do not attempt to repair a defective electrical device yourself!
Problem
The device does not
work.
storage.
Possible cause/solution
Are batteries inserted in the device? Check the correct
polarity.
Are the batteries empty? Insert new batteries. Use a sui-
table mains plug to check whether the device works.
Is the water reservoir fi tted correctly?
Have you pressed the On/Off switch?
18

Publicité

Table des Matières
loading

Produits Connexes pour MAAX Z 07134

Table des Matières