Beurer HA 55 Pair Mode D'emploi page 36

Charging:
1. Make sure that the device is switched off and
then insert it into one of the charger slots so
that it clicks into place.
Note: Please ensure that you insert the
device correctly into the charger so that it
can be charged correctly. The charger is
equipped with charging slots that enable
you to insert the device in the correct po-
sition. Allow the device to click into place in
one of these charging slots (Fig. 1) so that
the power switch sits in the opening (Fig. 2).
You can charge one or both hearing amplifiers
at the same time.
2. Connect the charger to a USB adapter to use it via a socket, or
plug the charger directly into a USB port without a USB adapter.
3. The red charging LED lights up during the charging process. When
charging is complete, the charging LED lights up green; a full
charge usually takes about seven hours.
4. When charging is complete, disconnect the charger from the
mains and remove the hearing amplifier(s) from the charger.
36
Fig. 1
Fig. 2