Velleman VMM500 Mode D'emploi page 17

At least, place a pause
When complete, we compile the program to generate a .hex file. Click on the download button and save the
.hex file to the Downloads
Plug the micro:bit into the USB port via the micro-USB cable. Then, drag and drop the .hex-file (from the
Downloads folder) onto the micro:bit
Ring:bit Car code
Drag and drop the blocks in the code drawer as shown below, and download this code into the second
micro:bit.
When complete, we compile the program to generate a .hex file. Click on the download button and save the
.hex file to the Downloads
Plug the second micro:bit into the USB port via the micro-USB cable. Then, drag and drop the .hex-file (from
the Downloads folder) onto the micro:bit
control.
V. 01 – 17/01/2019
block under the else logic and set it to 100 (100 milliseconds).
folder (C:\downloads). This .hex file is ready to be uploaded to the micro:bit.
Removable device
folder (C:\downloads). This .hex file is ready to be uploaded to the micro:bit.
Removable device
VMM500
to upload the programme.
1. Set the radio group. Keep the sender
and receiver the same.
2. Set the pins for the servos.
3. Save the received numbers into a
variable item.
4. Judge the number received. 1 means
to
5. 2 means to
6. 3 means to
7. Other means
8. Download the programme into
micro:bit.
to upload the programme for the remote
17
move forward.
turn left.
turn right.
to stop.
©Velleman nv