Velleman VMM500 Mode D'emploi page 16

Remote control code
The block radio set group
on start block. Set the number on 7.
Then, we make a forever
Then click on the gear icon again, and drag and drop the new created logic function under the
Now, place the block button A+B is pressed
the first else if logic, and block
in the code drawer menu.
Now, place the radio send number 1
drop a second radio send number 2
drop a third radio send number 3
fourth radio send number 0 block next to the
the code drawer menu.
V. 01 – 17/01/2019
can be found in the menu of the code drawer Radio. Drag and drop this block in the
loop. In this loop, we add a logic function:
next to the first
button B is pressed
block next to the first
block next to the second
block next to the third
else
VMM500
1. Set the radio group. Keep the sender and
receiver the same.
2. Press buttons A + B to
3. Press button A to
4. Press button B to
5. If there is no operation,
6. Download the programme into micro:bit.
if  then  else
Click on the gear icon for more
options. Then, drag and drop the
else if logic in the following
order.
if logic. Place block
next to the second else if
then logic and set the number to 1. Drag and
then logic and set the number to 2. Drag and
then logic and set the number to 3. Drag and drop a
logic and set the number to 0. The blocks can be found in
16
send number 1.
send number 2.
send number 3.
send number
if.
forever loop.
button A is pressed
logic. The blocks can be found
©Velleman nv
0.
next to