Publicité
english
GB
Positioning/Unpacking
1
Important: To the installer: Installation of these units should be carried out by a competent person and the appropriate codes of
practice adhered to, thus ensuring safe installation.
Pass to the user: do not discard this document: it contains important guidelines on Operation, Loading, Cleaning and Maintenance
and should be kept for reference.
DISPOSAL REQUIREMENTS
If not disposed of properly all refrigerators have components that can be harmful to the environment. All old refrigerators
must be disposed of by appropriately registered and licensed waste contractors, and in accordance with National laws and
regulations.
Important: Ensure a minimum clearance of 150mm above the unit and adequate ventilation for efficient operation. Where possible, ensure the
unit is away from a heat source.
Unpacking: The unit is delivered on a pallet and shrink-wrapped. Documentation is inserted into a clear pocket inside the unit. Carefully remove
the protective plastic film and cardboard from the unit exterior and from the door opening surround making sure that any sharp instrument used
does not cause damage, plus remove any quality labels.
Cabinet removal from the pallet: Remove the shelf holding the package containing the castors. Remove the retaining bolts which secure the
unit to the pallet. Move the unit over the front of the pallet fit the lockable castors in the mounting holes. To fit the rear castors, lock the front
castors, tilt the unit forwards, remove the pallet and fit the castors in the mounting holes. Ensure that all are tightened firmly into position.
On Double door cabinets, ensure 3 castors are fitted at the front.
Ensure during installation the unit is level if not the door/s may not close correctly. Adjust castors by inserting spacers, supplied separately, under
the appropriate castor and the base of the unit until level.
Counter removal from the pallet:
Counters fitted with castors - Remove fittings from inside the unit and ensure all drawers and doors are locked before removal from the pallet.
Cut the heavy duty cable ties that hold the front castors to the pallet. Unlock the castors and then carefully roll the unit forward off the pallet.
Counters fitted with legs - Remove fittings from inside the unit and ensure all drawers and doors are locked before removal from the pallet.
Remove the fixing blocks located in front of the legs at the front of the unit and cut the straps securing the unit to the pallet.
Carefully manoeuvre the unit forward, off the pallet.
The unit has slotted removable shelf supports allowing flexible shelf positioning. Ensure the trayslides/clips are
Shelf Supports
2
fitted parallel and level after fitting.
When loading product onto the shelves ensure that it does nor overflow the rear and sides as this will restrict
airflow throughout the cabinet.
If the cabinet has been laid on its back at any time DO NOT switch on immediately but leave in the
Start Up & Operation
3
upright position for at least 60 minutes.
user operation guidelines
Insert the fused plug into the wall socket and switch on the mains. The cabinet will start automatically and
4
display the actual internal temperature. As the operating temperature has been pre-set, allow the cabinet to
reach its normal operating temperature before loading.
i set
Start Up & Self Test: This indication is only displayed during the first three seconds following the mains electrical
5
Initial Start Up
power being applied to the unit. During this period the controller performs a self-check.
Once the self-check has been completed
2
Controller
❄
❄
❄
OFF
will be displayed.
-
11
Publicité
