Paoli Avvitatori BUTTERFLY Manuel D'utilisation Et D'entretien page 13

OPERATING AND MAINTENANCE MANUAL
OPERATING INSTRUCTIONS
L Always use an impact wrench with the
tightening torque corresponding to the one
required by the application.
L If by mistake you have used a higher torque
than the one required:
⚪ in the case of screwing, replace the bolt
and reform the tread you screwed it onto,
because of it yielding;
⚪ in the case of unscrewing, replace the
bolt anyhow and check the tread you
screwed it onto.
ACCESSORIES ASSEMBLY
When changing accessory, always disconnect
the pressure lines.
Use only accessories suitable for the job.
MAINTENANCE
L Every three weeks run the wheel gun
clockwise and
special oil for Paoli air impact wrench
motors (~5cc) or very fluid oil for air tools
into the air inlet. These operations must be
performed in a suitably equipped working
environment, complete with extraction
equipment for nebulised particles. Use
personal protective equipment.
L Drain condensation at the air filter and the
compressor daily (view figure
SCRAPPING
Separate the components on the basis of the nature of the materials of which they are made.
Translations of the original operating instructions
anticlockwise putting
Fig.1).
L If you have used a lower torque, screw
on again using an appliance with the
right torque, in order to avoid the risks of
insecure tightening.
L If you avoid operating at a higher pressure
than the one required you will save energy,
make less noise, and have less wear on the
appliance.
L "Square drive without hole and with
retainer ring": Insert the accessory "A" in
the square drive of the tool, with an axial
pressure (view figure
L Indicate the parts most subject to wear,
to be dismantled and checked at regular
intervals, as well as a list of malfunctions, if
any, and the corrective action.
L If the tool is left unused for long periods
we recommend putting some oil into the
air inlet and letting it run for a few seconds
before putting it away. In this way the internal
components will remain lubricated.
L Spare parts can be purchased in the "service kit"
package. Details of the service kit components
are available on our general catalogue.
- The original language of these instructions is Italian.
Fig.4).
ENGLISH
13