Publicité
Les langues disponibles
Les langues disponibles
English
1.
To assemble, disassemble and adjust the cutting tools, insert the clip holder (1) and tighten with a
torque wrench to 5Nm.
2. During the assembly or the dismantling of your cutting tools, to use the supplied spanner.
3.
The tool shank diameter should never have a difference of more than 0.4 mm compared to the
clamping diameter of collet.
Example: clamping diameter 9.5 mm => Shank diameter 9.1 mm minimum.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
ZBD0-CR
1
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
ZBD0-CR 1- mode
BT
Validation: 12.12.12
5Nm
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
office@pcm.ch
Document:
d'emploi 1-
Page: 2 de 4
Publicité
