Kobra 410 TS Mode D'emploi page 12

If you have any problems with your shredder, check the symptoms and solutions below.
If you are still unable to fix the problem contact your nearest Kobra dealer.
Do not open the shredder head to try to repair it. You could risk serious electrical shock and invalidate your guarantee
PROBLEM
The shredder does not
come on.
The shredder never
stops.
Significant reduction in
cutting capacity.
In accordance with:
The manufacturer: ELCOMAN SRL
VIA GORIZIA,9
Declares herewith that the following paper shredders comply with the standards of the LVD Directive LVD 2006/95/CE
- KOBRA series : Kobra 410TS
Applied standards:
EN 60950-1 :2006+A1:2010+A11 :2009
EN 55014-1 (2006) + A1 (2009)
EN 55014-2 (1997)+A1 (2001) + A2 (2008)
EN 61000-3-2 (2006) + A1 (2009) +A2 (2009)
EN 61000-3-3 (2008)
Bovisio Masciago, 02.03.2012
A.DE ROSA
T O
EchnicAl fficE
WHAT YOU SEE
- The led (F) does not come on
and the ENERGY SMART led (G)
does not come on
- The led (5) comes on
- Led (4) comes on
-Led bar (F) comes on
- Led bar (F) on, cutting blades
operating
- Capacity reduced compa-
red with capacity seen with
cutting blades oiled.
DECLARATION OF CONFORMITy
- directive LVD 2006/95/CE
- directive EMC (2004/108/CE)
- RoHS (2011/65/EU)
20813 BOVISIO MASCIAGO (MB) – ITALY-
TROUBLESHOOTING
CAUSE
- Switch( P and E) in the OFF
position
- Power cable not connected
properly.
- There is no electrical power.
- Door (A) not closed properly
- Bag full (D).
- Motor in heat protection
mode.
- Material and/or dirt deposited
on electronic eyes or between
the electronic eyes (1A) and
(10A).
- Lubrication required for cut-
ting blades
EN 61000-4-2(1995)+A1(1998) + A2 (2001)
EN 61000-4-4(2004)
EN 61000-4-5(2006)
EN 61000-4-6(2007)
EN 61000-4-11 (2004)
12
ACTION
- Press switch (E)
- Check that the power cable is
plugged in properly.
- Check the power is switched on
at the plug socket.
- Close the door properly
- Empty the bag
- Wait 15 minutes for the motor
to cool down
- Remove any deposit from the
electronic eyes and free them
- Replace empty oil container
with a full one