ENGLISH
Maintenance
Fuel fi lter replacement
Nut and screw tightening and
leakage check
Lubrication
Engine coolant line sleeve check
Drive system pump oil fi lter
check
Hydraulic system oil suction fi lter
replacement
Alternator belt replacement
Cab air fi lter replacement
Injector calibration and cleaning
Climate control system belt
replacement
Engine coolant replacement
Hydraulic system oil change
Brake system check
Hydraulic system pump pressure
check
Minor engine overhaul
Major engine overhaul
(1): Or every 6 months
(2): Maintenance to be performed by Lombardini authorised Service Center
(3): Or every 2 years
(4): After 5,000 hours
(5): After 10,000 hours
(6): For the relevant procedure see the Service Manual, at any Nilfi sk-Advance Service Center.
(7): Every year, if the machine is not frequently used.
(8): If a lower-quality oil is used, change it every 125 hours.
HOPPER CLEANING
WARNING!
Protect body parts (eyes, hair, hands, etc.) properly, when performing cleaning procedures using
compressed air or water gun.
Empty the hopper (2, Fig. F), drive the machine to the appointed cleaning/washing area, then perform the following procedure:
1.
Engage the parking brake (21, Fig. B-C).
2.
Lift the hopper (2, Fig. F), according to the procedure shown in the relevant paragraph.
3.
Open the skirt (19, Fig. F).
4.
Install the support rods (4, Fig. F).
5.
Clean the hopper with pressurized water.
CAUTION!
With pressurized water clean the skirt and the lower part of the hopper only, to avoid dampening the closed
pocket fi lter (26, Fig. E).
18
USER MANUAL
Running-in period
Every 10 hours
(after the fi rst 24
or before use
hours)
(6)
(6)
(6)
33014097(2)2006-12 A
Every
Every
200
600
hours
hours
(7)
(6)
(6)
(7)(6)
(6)
(6)
(3)(6)
(1)
SR 1800S D 2WD
Every
Every
Long
1,200
2,400
periods
hours
hours
(2)(3)(6)
(6)
(3)(6)
(3)(6)
(6)
(6)
(2)(4)(6)
(2)(5)(6)