Features Of The W-890R; Front Panel - Teac W-890R-B Mode D'emploi

Front panel

POWER switch
This switches the unit power between off and on.
NOTE
The apparatus draws nominal non-operating power from the AC
outlet with its POWER in the off position.
TAPE I compartment
RTZ key (TAPE I only)
This key returns the tape to the counter zero point.
COUNTER RESET keys
Pressing these keys reset the tape counter readings for TAPE I and
TAPE II, respectively.
Synchro reverse key (SYNC REVERSE)
Pressing this key activates the synchro reverse dubbing function.
REPEAT key
This allows repeat playback of a selected section of the tape.
Display
This shows tape counters, level meters, etc.
Parallel record key (PARALLEL REC)
This key lets you simultaneously record on both decks.
Dubbing start key (DUB START)
This key is used when copying the contents of a tape from TAPE I
to TAPE II, either at normal or high speed.
TAPE II compartment
8

Features of the W-890R

Reverse mode switch (REV MODE)
This switch is used to switch between reverse modes.
TIMER switch
This switch is provided for use with a commercially available
audio timer, to allow timer controlled recording or playback.
Normally, leave this switch to the OFF position.
DOLBY NR switch
This switch toggles the Dolby Noise Reduction system on/off. In
playback you need to set this switch to the same position as when
the recording was made.
EJECT ( ) keys
Pressing these keys opens the TAPE I and TAPE II compartments.
MIC jack and level control
Insert your microphone into this jack and use the knob to adjust
the level of mic input.
NOTE
The MIC jack is mono. You cannot use a stereo microphone with
this cassette deck.
Headphones jack (PHONES)
Plug your headphones into this jack.
PITCH CONTROL
This control is used to vary the playback speed.
REC LEVEL
This control is used to adjust the recording level.