Operation Instructions; Service And Replacement Parts; Warranty; Disposal - erba 33257 Mode D'emploi

GB - INSTRUCTION MANUAL

8. OPERATION INSTRUCTIONS

Make sure that the structure (steel pole) to which the support arm is attached is firmly anchored to
the ground and does not tilt in any direction.
The support arm must be completely horizontal at all times so that the hoist can roll and unroll the
cable correctly.
Never exceed the maximum load of the support arm – the weight of the hoist itself must be included
in the calculation!
Before you start using the support arm a load test must be performed. Put a hoist on the support
arm and test it without any load. Then gradually increase the load untill you reach the load limit.
Remove the hoist and check the bolts – they must still be fastened at 70Nm.

9. SERVICE AND REPLACEMENT PARTS

Use original spare parts only.

10. WARRANTY

Legal warranty regulations apply.

11. DISPOSAL

Our products are packed in order to prevent damage during transport. Packing materials are va-
luable resurces and therefore can and should be recycled. The product itself consists of various
materials (metals, oils, plastic, etc.) and should be disposed with care and in accordance with your
federal and local disposal regulations.

12. LEGAL INFORMATION

All rights reserved. This manual is copyrighted. Reproduction in and form (digital, print, etc.) is
strictly prohibited without the written permission of ERBA GmbH.
ERBA GmbH
A-1230 Wien
Talpagasse 6
Servicehotline: Tel: +43(0) 1 930 10 - 160 · Fax: +43(0) 1 930 10 - 960 · E-Mail: service@erba.at
Page 13
Changes, print, punctuation and other errors reserved!
Instruction manual
33257
Issue: 12/2018