RODCRAFT RC2437XI Manuel page 7

4. Maintenance
Generally for the device maintenance the environmental regulations of the respective country are to be observed.
After first year, disassemble and inspect the tool every three 3 months if the tool is used every day. Replace damaged or worn parts.
Always ensure that the machine is disconnected from energy source (compressed air) to avoid accidental operation.
To keep downtime to a minimum, use repair kit define in parts list.
Motor Lubrication
• 1. Only use RODCRAFT accessory air oil
2. Clean air intake nipple before use
3. Fill air oil (approx. 3 drops) into the air intake nipple and briefly operate the machine.
Follow abovementioned steps before and after using the machine. This increases the machine's service life.
•
•
Lubricate the striking mechanism as follows:
1. Only use commercially available grease with MoS
2. Use grease gun with matching connector for the grease nipple on the striking mechanism casing.
3. Clean grease nipple before use.
• Greasing frequency and amount of grease with specifications MoS
by reduced torque and power. Now it is high time to grease the striking mechanism.
5. Disposal
The disposal of this equipment must follow the legislation of the respective country.
All damaged, badly worn or improperly functioning devices MUST BE TAKEN OUT OF OPERATION.
Repair only by technical maintenance staff.
Use the equipment only for its intended use as described above, any other use is expressly excluded! We are not responsible for injuries
and damage due to inappropriate use and misuse and/or noncompliance of safety precautions; this is not covered by the warranty.
Valid for:
RC2437XI
RC2447XI
RC2457XI
RC2477XI
Origin of the product: Made in Taiwan
is in conformity with the requirements of the council Directives on the approximation of the laws of the Member States relating :
to „Machinery":
applicable harmonised standard(s) :
CP
Technical File
ZAC de la Lorie -38, rue Bobby Sands, B.P10273
available at the
44818 Saint-Herblain Cedex, France
EU Technocenter
Rodcraft Customer Center
Company name
Langemarckstr.35 bis
and address:
45141 Essen- Germany
We hereby declare that the following described machine complies with the general safety and health requirements of below mentioned EU directives due to its design and
conception and the type circulated by ourselves. This declaration becomes invalid if the machine is modified without our approval.
specifications.
2
EC DECLARATION
2006/42/EC (17/05/2006)
EN ISO 11148-6:2012
Visit our Internet presence at www.rodcraft.com
Here you can also download our manuals.
With further questions contact your nearest Rodcraft branch or the authorized dealer.
RODCRAFT PNEUMATIC TOOLS
EN
depends on the use of the machine. Generally the need for maintenance can be seen
2
Place and date of
Nicolas Lebreton
R&D Manager
Serial: 011 to 129
Serial: 011 to 129
Serial: 011 to 129
Serial: 011 to 129
44818 Saint-Herblain,
issue:
29.04.2013
France
7