Kampa Gale PU0165 Guide D'utilisation page 5

3. Insert the other end of the hose into the item that requires inflation using the
appropriate nozzle adapter. Kampa
use either the screw-on adapter (K) or the push-fit adapter (L) as indicated in
the Parts Identification section. The screw-on adapter has been designed by
Kampa ® for easy but secure fitment as it screws onto the valve and is more
suited to products with a single inflation point.
4. The pressure mode can be changed by pressing button (C) in order to select
either 'PSI', 'BAR' or 'KPa'. Keep pressing until the required mode is shown on
the display.
5. Set the desired pressure by using the + and - buttons (D & E). The pressure
that can be set ranges from 0 to 12.5 PSI (0-0.861 BAR/0-86.1 KPa). Press
and hold the + or - buttons to alter the pressure shown quickly or press
and release the buttons to adjust the pressure in increments of 0.5 PSI. The
pump is factory set at 10 PSI (0.689 BAR/68.9 KPa). After the first use, the last
pressure used will be displayed.
6. The optimum pressure for Kampa
0.758 BAR/62.05-75.84KPa). Kampa
inflated to between 7-9PSI (0.482-0.62 BAR/48.26-75.84 KPa). Kampa
inflatable Party Tents should be inflated to between 8-10PSI (0.551-0.689
BAR/55.1-68.9 KPa).
7 . Press the Start/Stop button (F) to begin inflation. Note: If no buttons have
been pressed for 30 seconds the unit will go into standby mode; simply
press any button to activate the unit.
8. Once the pre-set pressure is reached, the pump will switch off automatically.
Note: At first it will take time for the pressure reading on the LCD display to
increase. This is normal as, initially, a large volume of air is needed to fill the
AirFrame before any significant change in pressure is detected.
9. Remove the hose from the valve.
10. Turn off the vehicle or other 12V power source and disconnect the 12V plug.
Note: If you need to stop pump operation at any time press the Start/Stop
button (F).
Recycling Advice
Waste electrical products should not be disposed of with household
waste. Please recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice.
AIR awnings, tents and party tents can
®
AIR awnings is between 9-11PSI (0.62-
®
AIR tents and travel pods should be
®
5
®
PU0165-UM-01-17 Rev.A