FUST NOVAMATIC SUPER OKO+2230.1-IB Notice D'utilisation page 40

40
Problem
The lamp does not work.
It is too warm in the
freezer.
It is too cold inside the
freezer.
The appliance does not
work at all. Neither cool-
ing nor lighting works.
Customer Service
If your appliance is still not working properly
after making the above checks, contact the
nearest service centre.
To obtain fast service, it is essential that
when you apply for it you specify the model
Possible cause
The valve is blocked.
The lamp is defective.
The temperature is not set cor-
rectly.
The lid does not close tightly or
it is not shut properly.
Before freezing the appliance
was not precooled sufficiently.
Large quantities of food to be
frozen were put in at the same
time.
Food placed in the appliance
was too warm.
Products to be frozen are
placed too closely to each other.
The lid has been opened often.
The lid has been opened for a
long time.
The temperature is not set cor-
rectly.
Plug is not connected to the
mains socket properly.
Power does not reach the appli-
ance.
The appliance is not switched
on.
There is no voltage in the mains
socket (try to connect another
appliance into it).
Check the valve.
Refer to "Replacing the lamp".
Set a lower temperature.
Check if the lid closes well and
the gasket is undamaged and
clean.
Pre-cool the appliance for enough
time.
Wait some hours and then check
the temperature again. Next time
insert smaller quantities of food to
be frozen at any one time.
Allow food to cool to room tem-
perature before storing.
Place the products in a way so
that cold air could circulate
among them.
Try to not open the lid often.
Do not leave the lid open longer
than necessary.
Set a warmer temperature.
Connect the mains plug properly.
Try connecting another electrical
device to the power outlet.
Switch on the appliance.
Call an electrician.
and serial number of your appliance which
can be found either on the guarantee certifi-
cate or on the rating plate located on the
external right side of the appliance.
Solution