Avdel 07220 Manuel D'instructions page 33

A c c e s s o r i e s
Use 07500-06800 collar splitter to cut
is necessary to use Adaptor Kit (part number 07220-09000) and to fit a Stop Kit (part number 07229-08973) to reduce the stroke of
the tool.
C o l l a r S p l i t t e r A s s e m b l y, A d a p t o r K i t ( 0 7 2 2 0 - 0 9 0 0 0 ) a n d S t o p K i t ( 0 7 2 2 9 - 0 8 9 7 3 )
SMALL
COLLAR
SPLITTER
•
To fit these collar splitters, first disconnect the air supply to the tool.
•
Remove the pin tail Deflector 52 from tool.
•
Remove Screws 50 (6 off).
•
Insert stop (boss end first) into Head Cap 63.
•
Secure with screws (part number 07001-00002) supplied with the Stop Kit.
•
Remove the nose assembly, if fitted.
•
Lubricate the collar splitter cam faces, bearing faces and any moving parts with Moly Lithium Grease.
•
Pull forward and rotate through 90° the outer ring of the head extension assembly on tool to expose slots.
•
Holding the head piston with a
spanner*.
•
Push the anvil adaptor over the collet adaptor and lining up its bayonet with the matching slots of the head extension, push in and
turn through 90°.
•
Rotate the outer ring of the head extension to lock into position.
•
Insert the assembled collar splitter into the anvil adaptor and screw onto the end of the collet adaptor - Tighten the nose retaining
nut onto the anvil adaptor with a spanner*.
•
To operate, push the collar splitter hard over the collar and depress trigger.
•
5 3
To cut / " or / " Avdelok
16 8
required.
•
To fit these larger collar splitters, first disconnect the air supply and remove any fitted nose assembly.
•
Fit directly onto the head piston in the same manner as the collet and anvil adaptors above.
3 ®
/ " Avdelok and 07500-06900 to cut
16
ANVIL
ADAPTOR
3
/ " Allen key* through the back of the tool, tighten the collet adaptor onto the head piston with a
8
®
use 07220-03700 and 07220-03900 collar splitters respectively - No adaptor or stop kit is
* Refers to items included in the 07220 Service Kit. For complete list see page 14.
Item numbers in bold refer to the General Assembly drawing and Parts List (pages 18-19).
1
/ " Avdelok
4
COLLET
ADAPTOR
TOOL
ADAPTOR KIT
®
. When using either of these splitters it
SCREWS
STOP
STOP KIT
9