SOLAC BA5606 Mode D'emploi page 8

to adapt the speed of the appliance to the type
of work that needs to be done.
TURBO FUNCTION:
The appliance has a Turbo function. By acti-
•
vating the Turbo function (C) all the power of
the motor becomes available, thus obtaining a
finer finish in the final texture of the product.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
Stop the appliance by releasing the pressure
•
on the on/off button (B).
Unplug the appliance from the mains.
•
Clean the appliance.
•
ACCESSORIES:
STICK BLENDER ACCESSORY (FIG.1):
This accessory is used for making sauces,
•
soups, mayonnaise, milkshakes, baby food,
crush ice ...
Attach the stick to motor body and turn in the
•
direction of the arrow (Fig.1.1).
Put the food to be prepared in the jar and
•
switch the appliance on.
For further cleaning, detach and remove the
•
stick by turning in the opposite direction of the
arrow.
CHOPPING ACCESSORY (FIG.2):
This accessory is used to chop vegetables or
•
meat...
Put the food to be prepared in the chopping
•
container and attach the cover firmly. (Fig. 2.1).
Attach the unit to the cover turning in the di-
•
rection of the arrow and switch the appliance
on (be careful: do not switch the appliance on
if the whole unit is not properly fitted and con-
nected together) (Fig.2.2).
Stop the appliance when the food reaches the
•
desired texture.
Detach the unit from the lid and the lid from
•
the chopper.
Note 1: Do not work with Turbo funcion with
•
this accessory attached.
WHISK ACCESSORY (FIG.3):
This accessory is used to whip cream, beat
•
egg whites...
Attach the unit to the motor body and turn in
•
the direction of the arrow (Fig. 3.1).
Put the food into a receptacle and switch the
•
appliance on. For best results, turn the whisk
clockwise.
Remove the whisk accessory and release the
•
motor body.
Note 1: Do not work at high speeds with this
•
accessory attached, as this would cause de-
fects in the whisk (spinning its wires).
SAFETY THERMAL PROTECTOR:
The appliance has a safety device, which pro-
•
tects the appliance from overheating.
If the appliance turns itself off and does not
•
switch itself on again, disconnect it from the
mains supply, and wait for approximately 15
minutes before reconnecting. If the machine
does not start again seek authorised technical
assistance.
CLEANING
Disconnect the appliance from the mains and
•
allow it to cool before undertaking any cleaning
task.
Clean the equipment with a damp cloth with a
•
few drops of washing-up liquid and then dry.
Do not use solvents, or products with an acid
•
or base pH such as bleach, or abrasive prod-
ucts, for cleaning the appliance.
Never submerge the appliance in water or any
•
other liquid or place it under running water.
During the cleaning process, take special care
•
with the blades, as they are very sharp.
It is advisable to clean the appliance regularly
•
and remove any food remains.
If the appliance is not in good condition of
•
cleanliness, its surface may degrade and in-
exorably affect the duration of the appliance's
useful life and could become unsafe to use.
The following pieces may be washed in a dish-
•
washer (using a soft cleaning program):
- Stick blender.
- Measuring cup.
- Chopper (without lid).
The draining/drying position of the articles
•
washable in the dishwasher or in the sink must
allow the water to drain away easily. (Fig. 4)
Then dry all parts before its assembly and stor-
•
age.
EN