Beko RFSA240M31WN Notice D'utilisation page 12

EN
4. Refer to "Cleaning and Care" section to
prepare your appliance for use.
Temperature control and adjustment
The freezer temperature is influenced by the
freezer temperature set button ( recomanded
are 2 or 3 position).
Generally, this temperature is bellow -18°C
lowertemperatures can be obtained by
adjusting the thermostat knob towards
position MAX.
We recommend checking the temperature
with a thermometer to ensure that the storage
compartments are kept to the desired
temperature. Remember to take the reading
immediately since the thermometer
temperature will rise very rapidly after you
remove it from the freezer.
Please remember that each time the door is
opened cold air escapes and the internal
temperature rises. Therefore never leave the
door open and ensure it is closed immediately
after food is put in or removed.
Before operating
Final Check
Before you start using the freezer check that:
1. The feet have been adjusted for perfect
levelling.
2. The interior is dry and air can circulate
freely at the rear.
3. The interior is clean as recommended
under "CLEANING AND CARE."
4. The plug is inserted into the wall socket and
the electricity supply is switched on. Avoid
accidental disconnection by taping over the
switch.
And note that:
5. You will hear a noise as the compressor
starts up. The liquid and gases sealed within
the refrigeration system may also make some
noise, whether the compressor is running or
not. This is quite normal.
6. To freeze the fresh foods use the
compartment marked with 4 stars
(recomanded second shelf).
7. Don't put in freezer a too big quantity of
foods in the same time. The foods quality is
well kept if they are deeply frozen in the
shortest time possible.
Therefore it is preferable do not exceed the
freezing capacity of the appliance shown in
"Appliance record". The thermostat knob shall
be adjusted in order to obtain the lowest
temperature inside the freezer, with the fast
freeze function activated and the orange lamp
lighting.
8. Do not load the appliance immediately it is
switched on. Wait until the correct storage
temperature has been reached. We
recommend that you check the temperature
with an accurate thermometer (see;
Temperature Control and Adjustment).
Important Note:
If there is a power failure do not open the
door. Frozen food should not be affected if the
failure lasts for less than 16 hours. If the
failure is longer, then the food should be
checked and either eaten immediately or
cooked and then re-frozen.
Freezer control panel
Item 5
The control panel adjusts the temperature in
the freezer and has the following functions:
1 - Orange led - Fast freeze on
When you turn the freezer temperature set
buton (4) to the „FAST FREEZE" position, the
orange led (1) will lit and the appliance will run
in lowest temperature conditions. The orange
LED stops to lit after 50 hours of running in
lowest temperature conditions.
2 - Green led - electricity on (Voltage)
Lights when the appliance is
connected to the network and remains lit as
long as it is
available power supply. LED green
does not provide information on temperature
inside the freezer.
3 - Red Led - High Temperature Alarm
4 - Setting temperature buton
High temperature alarm
After the appliance is turned on for the first
time the alarm is not active for 12 hours (red
led is off).
After this period, red led can lights (red led is
on) in the following cases:
3
Instruction for use