Carbest 82277 Manuel D'utilisation page 21

UK
Carbest Pure Sine Wave Inverter with built-in priority switch| 82277/82278/82279
WARNING!
!
Reverse polarity will burn the fuse or may cause the damage of the device.
So please pay more attention to it. Damage caused by wrong connection, is not
covered by warranty.
The inverter has to be connected only to batteries with a normal output voltage of
12 volts. The power source can be a 12 V battery or several 12 V batteries connected
in parallel to increase the backup time. The unit will not operate from a 6-volt
battery, and will sustain permanent damage when connected to a 24-volt battery.
Keep ventilation when using batteries. Batteries may generate flammable gas
during charging or discharging.
Sparking may occur when the unit is connected with the battery, make sure that
no flammable fumes are present before making any connections.
Please use the DC cables which are inside the packaging to ensure the best
performance.
6.2. For installation inside a car, connect the grounding terminal with main
chassis point� Any connection of the AC output with further installation has
to be done by an approved technician�
WARNING!
! Before using the inverter, please provide a grounding cable. There is a terminal
fitted with a nut in the inverter is output panel. Please choose heavy duty, green
insulated cable and put it 1–2 m or more deep into the ground.
6.3. If the charger is switched ON and inverter is connected to public power, it
can charge your battery�
6.4. Plug your AC appliance into the inverter's outlet�
Make sure your appliance has been turned off before connecting it to the unit.
Please turn your appliances on only one by one. Now your appliance is functioning.
If there is an overload, the red LED 3 is on and the inverter will shut down. To
reset, reduce the load and if your appliance require power within the inverter's
rated power, the inverter will restart automatically.
6.5. Use the remote function (Only available with the remote controller)�
Please connect the controller to the remote port on inverter. When using this
function, turn the inverter or charger switch button to »REMOTE« option.You can
control the inverter or charge part separately.
WARNING!
!
We advise that you do not use appliances whose power are more than 90%
of the inverter's rated power� Although there is an overload protection, it
may damage the unit�
21