Introduction; Features; Operation Environment - Carbest 82277 Manuel D'utilisation

UK
Carbest Pure Sine Wave Inverter with built-in priority switch| 82277/82278/82279
1�

INTRODUCTION

Thank you for choosing our Carbest pure sine wave inverter with built-in priority
switch. It is a perfect combination consisting of a pure sine wave inverter, with
built-in priority switch, a bypass relais and a 3-stage battery charger. As soon as
the inverter is connected to the public power 230 V AC, it automatically switches
to use main AC power. The transfer time is less than 15 ms.
2�

FEATURES

Automatic Protection functions: earth leakage protection, reverse polarity, overload,
over voltage, over temperature, low voltage, short circuit.
Transfer time between bypass and inverter mode is very short, when public power
is disconnected Three LED indicators: Power, fault, charger
Pure sine wave output: THD <3 %
AVS protection function: low voltage, over voltage, time delay
Inverter and charger remote control function
3�

OPERATION ENVIRONMENT

For best operating performance, the inverter must be placed on flat surface, such
as ground or other solid surface. Install the inverter at a dry location. Do not allow
water and/or other liquids to come into contact with the device. For all marine
applications, do not install the inverter below or near the waterline and keep away
from moisture or water.
COOL� Ambient air temperature should be between 0°C non-condensing, and
40 °C. Do not place the inverter on or near a heating vent or equipment that are
generating heat above the regular room temperature. If possible, keep it away
from direct sunlight.
VENTILATION� Keep the area close to the inverter clear to ensure free air cir-
culation around the unit and do not place items at or across the inverter during
operation. A fan is helpful if the inverter is operating at maximum power outputs
for a longer time. The units will shut down if the internal temperature exceeds
operating temperature and restart after it has cooled down.
SAFETY� Do not use the inverter near flammable materials or in any locations
that may accumulate flammable fumes of gases.
17