Bosch Isio Instructions D'emploi page 16

Check that covers and guards are undamaged and
correctly fitted. Carry out necessary maintenance or
repairs before using.
If the machine should happen to fail despite the care
taken in manufacturing and testing, repair should be
carried out by an authorized customer service agent
for Bosch garden products.
For all correspondence and spare parts orders, al-
ways include the 10-digit part number (TYP) from
the nameplate of the machine!
Blade Maintenance
Always clean the cutting blades after operation and
lubricate with Bosch Maintenance spray. During
longer cutting jobs, we recommend periodically lu-
bricating the cutting blade with Bosch Maintenance
spray.
Visually check the condition of the cutting edges of
the cutting blade 1.
Ensure that the blade is covered with the blade
guard supplied when not in use.
Changing the blade
Wear gloves when changing the blade.
Removing
Push the SDS-blade cover release button 11
E F
and slide the cover 6 towards the On/Off switch 5.
Lift away from the housing.
Lift the blade 1 out.
G
Fitting
Fit the blade as shown aligning the holes in the
H
blade onto the drive pins.
When refitting the SDS drive cover ensure all 4 loca-
tion legs are inside the housing prior to sliding cover
into place.
Slide the blade cover back towards the
I J
blade 1 to secure.
Cleaning/Storage
Clean the exterior of the machine thoroughly using a
soft brush and cloth. Do not use water, solvents or
polishes. Remove all debris, especially from the
ventilation slots.
Store the machine in a secure dry place out of reach
of children. Do not place other objects on top of the
machine.
16 • F016 L70 473 • TMS • 17.10.06
Transport
The battery is tested in accordance with the
UN Handbook ST/SG/AC.10/11/Rev.3 Part III, Sub-
section 38.3. It has effective protection against inter-
nal overpressure and short circuiting as well as
measures for prevention against forced rupture and
dangerous reverse current.
The lithium equivalent contents contained in the bat-
tery is below the spilling limit values. Therefore, the
battery is not subject to the national and international
regulations governing dangerous goods, neither as
individual components nor when inserted into a ma-
chine. However, the Dangerous Goods Regulations
can be relevant when transporting several batteries.
In this case, it can be necessary to observe special
conditions (e. g. for packaging). For more details,
please refer to the instruction sheet under the follow-
ing Internet address: http://purchasing.bosch.com/
en/start/Allgemeines/Download/index.htm.
Disposal
Power tools, accessories and packaging should be
sorted for environmentally-friendly recycling.
Only for EC countries:
are no longer suitable for use must be separately
collected and sent for recovery in an environmen-
tally-friendly manner.
Battery packs/batteries:
Do not dispose of battery packs/batteries into
household waste, water or fire. Battery packs/batter-
ies must be collected, recycled or disposed of in an
environmentally-friendly way.
Only for EC countries:
Defective or dead batteries must be recycled ac-
cording to the directive 91/157/EEC.
English - 5
Do not dispose of power tools into
household waste!
According to the European Directive
2002/96/EC on waste electrical and
electronic equipment and its incorpo-
ration into national law, products that
Li-Ion:
Please observe the instructions in
the Section "Transport ".