Technical Data; Noise & Vibration; Troubleshooting - for_q Q-ARM 4038 BASIC Mode D'emploi

Technical Data

Type
Nominal voltage
Battery type and weight
No-load speed n
0
Cutting width
Cutting height
Grass bag capacity
Weight (acc. to EPTA Prodedure
01/2003) without battery
Sound pressure level L
pA
Sound power level L
wA
Vibration emission value a
h
Noise & Vibration
The values given in these instructions
have been measured in accordance
with a standardized measurement
procedure specified in EN 60335 and
can be used to compare appliances.
It may be used for a preliminary as-
sessment of exposure.
Warning! The vibration emis-
sion during actual use can
differ from the declared total value
depending on the use of the appli-
ance.
140 EN
FQ-ARM 4038 BASIC
40 V
FQ-LIO 4020 / 2,0 Ah / 0.9 kg
FQ-LIO 4040 / 4,0 Ah / 1.3 kg
FQ-LIO 4060 / 6,0 Ah / 1.7 kg
4000/min
370 mm
25-75 mm
40 litres
15.5 kg
83.0 dB(A), Uncertainty: 3dB(A)
96 dB(A), Uncertainty: 3dB(A)
2.0 m/s , Uncertainty: 1.5 m/s
2 2

Troubleshooting

Caution! Make sure the appliance is switched off and the battery is
removed. Always wear protective gloves.
Problem Possible cause
Motor does Battery empty
not run
Unsuitable cutting areas
Blade is blocked
Safety plug is not con-
nected
Battery is not correctly
inserted
Wrong cutting height
Motor power Wrong cutting height
drops
Discharge chute is
blocked
Poor and uneven cut
Collection
Unsuitable cutting areas
bag is not
filled suitably
Poor and uneven cut
Collection bag is full
Discharge chute is
blocked
Solution
Recharge battery
Start on short or already
mown grass.
Clean discharge chute and
housing (blade must rotate
freely)
Connect safety plug
Remove battery and insert
again
Set the wheels to the correct
cutting height
Set the wheels to the correct
cutting height
Clean discharge chute and
housing (blade must rotate
freely)
Replace the blade (contact
service center)
Set the wheels to the correct
cutting height
Allow lawn to dry
Replace the blade (contact
service center)
Empty the collection bag
Clean discharge chute and
housing (blade must rotate
freely)
EN 141