SCHOLTES LVI 12-66 Instructions Pour L'installation Et L'emploi page 20

Delayed start , Extra drying and Half load
You want to wash just half a load?
Remember to halve the amount of detergent.
Have you only got a few dishes that need washing? If so,
load them all on a single rack to save on water, detergent
and electricity. Press the "M" (Mode) button repeatedly until
symbol "N" is selected: the corresponding rectangle will light
up. Using button S (select), you can decide to wash a half-
load on the upper rack or on the lower one .
Each time you press it, a beep will sound and the
corresponding symbol will light up. The symbol for the selected
rack is displayed. Off means "no selection" has been made
Once you have made your selection, start the wash cycle by
pressing START.
This option is available with all wash cycles.
Do you want extra drying?
Before you start the selected wash cycle, press button "M"
(Mode) repeatedly until the extra drying symbol "G" is
selected, and the corresponding rectangle lights up. Press
button "S" (Select) and select On to enable the extra drying,
or Off to disable it. Remember that with the extra drying
enabled, the wash cycle will last longer to provide you with
dryer dishes.
This option is incompatible with the soak cycle.
GB
You decide when it starts.
When you have loaded the dishes, you can choose when to
start your dishwasher before setting the wash cycle desired.
Press button "M" (Mode) and then select the symbol
"F"corresponding to the delayed start:
the corresponding rectangle will darken. Now press button
"S" (Select) to delay the wash cycle start by 1 to 24 hours. If
you press the button again, the word "OFF" is displayed (no
selection made).
Each time the button is pressed, a beep will sound; once you
have made your selection, make sure the appliance door is
shut and start the wash cycle by pressing button "D" (START).
The countdown to the delayed start will begin on the display.
Once the countdown is up, the wash cycle begins and the
approximate amount of time left until the end of the wash
cycle is displayed.
Have you changed your mind?
If you change your mind and wish to set a different delay
press the Mode and Select buttons and repeat the selection.
If on the other hand you want to cancel the delay set and
you wish to start the wash cycle immediately, press the Select
button repeatedly until it is set to zero. The indicator light
"F"will turn off.
18