SCHOLTES LVI 12-66 Instructions Pour L'installation Et L'emploi page 19

Turning on the Appliance
First of all.
Insert the plug into the electricity socket to power the
dishwasher. Turn on the water tap completely and press the
Stand-by button "A".
The display turns on and 4 dashes appear: these indicate
that the dishwasher is awaiting instructions.
Starting and selecting the cycle.
To select the wash cycle, turn knob "P" clockwise; the
corresponding symbols will light up in sequence:
choose the cycle you deem most suited to the type of dishes
to be washed (take a look at page 19, where you will find
the wash cycle table).
Keep the Start "D"button pressed for a few seconds and
the wash cycle begins, but if you have left the dishwasher
door open, the word "DOOR" will be displayed; shut it and
press the same button again.
A beep sounds and then the wash cycle begins and only the
symbol corresponding to the wash cycle selected is displayed.
You can see the amount of time left until the end of the
wash cycle on the counter. Do not expect a precise countdown
as the wash cycle starts with an estimated cycle time that is
updated, thanks to the sensor it is fitted with, as the cycle
progresses, according to a number of parameters that ensure
maximum wash efficiency.
Cycle phase indicator lights
The dishwasher is provided with 4 indicator lights "H" which
come on in sequence as the appliance is performing that
specific phase of the wash cycle.
These phases are:
pre-wash
wash
rinses
drying
Cancelling or modifying a wash cycle in progress.....
You can modify the wash cycle in progress, if it has only just
started. Keep the Reset button "D" pressed for about 3
seconds: a prolonged beep will sound, followed by three
short beeps. Indicator light "I" turns off and the 4 dashes
appear to indicate that all the settings have been cancelled.
You are now free to re-set the correct wash cycle.
If you have left out a dish...
Interrupt the wash cycle by pressing the Stand-by button,
insert the dish you had forgotten and press the same button
again. The cycle will start up from where you interrupted it.
There's been a power failure? Have you opened the
dishwasher door?
The wash cycle stops and then restarts when the electricity
comes back on or when you shut the door.
Have you left the dishwasher door open?
The word "DOOR" flashes on the display. Shut the appliance
door and the wash cycle will start up again.
At the end of the wash cycle....
The end of the wash cycle is indicated by two short beeps
and the word "END" flashes on the display.
Warning:
Turn the display off by pressing button "A", unplug the
appliance from the electricity socket to cut off the power
supply; the power supply cable should consequently be
easily accessible.
• Turn off the water tap.
• Wait a few minutes before unloading the dishes: they are
very hot! If you wait a little while, they dry better.
• Empty the lower rack first.
Make sure the wash cycle has ended before removing the
dishes!
Warning:
If opening the door soon after the end of the programme, or
during it, stand away from the Dishwasher, to avoid possible
injury from hot steam.
"Duo Wash" Cycle:
This is a special cycle that runs a differentiated wash on the
two racks: delicate for glassware and glasses on the upper
rack and heavy duty for saucepans and frying pans on the
lower rack.
Press the (Mode) button "M"and select the Duo-Wash
symbol, then press "S" (Select):"on" means it is selected
and the corresponding rectangle will light up, whereas "off"
means it is disabled; after approx. 5 seconds, you will
automatically quit the menu.
Now press Start and the wash cycle starts with a beep.
17
GB