Connecting The Printer - Sony MSAC-PR1 Mode D'emploi

10
11
12
GB
12
Device Selection (Windows NT 4.0 only)
With Windows NT 4.0, the following screen appears.
Click the "OK" button.
Setup Complete
With Windows 95/98 you can use the PC card straight
away. With Windows NT4.0, you have to restart the
computer before you can use the PC card.

Connecting the Printer

Turn the power to the PC off and connect the printer.
If the printer does not run normally.
Refer to "Changing Settings for Installation" C (page 15) and D
(page 16).
Installing a new printer.
Turn the PC off, remove the device from the PC, and then
connect the printer cable directly to the parallel port. After
installing the printer driver, reconnect the printer cable to the
printer connector of this device, and perform a test print. If the
printing is unsatisfactory, refer to "Changing Settings for
Installation" C (page 15) and D (page 16).