Parrot DISCO-PRO AG Guide Utilisateur page 17

Make sure that the two modules are properly
attached to the drone and that they are not likely to
come away during the flight.
Make sure that the micro USB device cable which
connects the drone to the multispectral sensor is
connected. Also check the micro-USB connection
between the sunshine sensor and the multispectral
sensor.
Make sure that the two sensors are calibrated.
For more information, see the Calibrating Sequoia
section.
Wait until the sunshine sensor indicator light is
green. When it is green this means that the GPS/
GNSS is enabled.
CONNECTING TO
THE PARROT DISCO-PRO
CONNECTING THE PARROT
SKYCONTROLLER 2 TO THE PARROT
DISCO WITH FREEFLIGHT PRO
Place the Parrot
1.
Press the Parrot Disco-Pro's On/off button.
> The button flashes red then green once the
GPS is connected.
2.
Press the On / Off switch on the Parrot
Skycontroller 2.
t surface.
Disco on a fla
17