B-Speech caran Manuel D'utilisation page 8

Turning the device On/Off
The device is turned on or off by pressing on the On/Off button for 3 secs.. When ON, the green
LED (right) flashes every 2 sec. Now the device is on stand by mode.
Pairing
The CARAN and your mobile phone must be paired before being used together. The CARAN
automatically chooses the "Handsfree" or "Headset" profile and pairs it with the mobile phone.
Details of the pairing process:
Note: Place your mobile phone and the B-Speech®Caran at a max. distance of 20cm apart.
1. Turn the CARAN off..
2. Keep the ON/OFF key down for about 8 sec. until both the ON sound and the Pairing sound
can be hear. The red and the green LED now flash alternatively.
3. Activate the Bluetooth function of your mobile phone and follow the method for pairing of your
mobile phone in its user manual. The CARAN will be found by your mobile phone. Choose the
CARAN from the list displayed by your mobile phone. Your phone will ask for the pairing code.
Enter "1234". This code is fixed at manufacture and can not be changed.
4. The CARAN is now paired with your mobile phone. Both devices are ready for use.
Important: If the pairing process fails, repeat the process. Once the connection is successful, the
CARAN is ready. You can then phone wirelessly, if the mobile phone is properly set up.
Note:
1. If you want to stop the pairing process, presson the Pairing button again. The CARAN in standby
mode.
2. Adjust the CARAN for a comfortable level of volume.
3. Adjust the microphone swivel handle for an optimum transmission to an angle of 120'.
Taking / Refusing a call
Press on the green "call taking" button to accept a call.
Press on the red "call refusing" button to refuse a call.
Vocal dialing function
Make sure that your mobile phone accepts vocal dialing. Activate the vocal dialing function of your
mobile phone first and record the vocal commands. Press the green "call taking" in standby mode.
Once you hear a beep, speak the stored name and the corresponding stored number will be dialed.
Re-dial of the last dialed phone number
Press on the red "call refusing" button in standy mode. The last dialed number will automatically
be re-dialed.
Second multi-function button
a) Incoming call
Conversation starts by pressing the multi-function button in the microphone handle once.
b) Ending a call
Press again on the multi-function button in the microphone handle for 2 – 3 sec. to end the
conversation.
c) Forwarding a call to the mobile phone
If you wish to forward a call to your mobile, press the multi function key for about 1 sec.
d) Vocal dialing
Press on the multi function button in standby mode to activate the vocal dialing.
Note: Some mobile phones do not have vocal dialing.
You will find further tips and references in the compability list at www.b-speech.de.
Indicator of the state of the batteries
If the charge of the batteries is low, you will be warned every 40 seconds by a flash of the indicator
and a BiBiBiBi sound. The red LED lights up as well. Please charge your batteries immediately.
Batteries charging
The CARAN uses, among others, 3 re-chargeable AAA batteries. The batteries are not fully charged
when you unpack the CARAN. We advise you to fully charge the batteries before first use, i.e.
until the indicator for the state of the batteries goes off.
The indicator of the state of the batteries lights up while charging takes place. Once the batteries
are fully charged, it goes off.