RoMedic BackBoardStraps Manuel D'utilisation page 4

Application and use
Dimensions
A: 110 cm
B: 8 cm
Care of the product:
Read the product label.
When in doubt, contact your Direct Healthcare Group representative for product trials, advice or information.
If you require additional information, contact your transfer specialist or our representative,
or visit www.directhealthcaregroup.com. Make sure you always have the most recent version of the manual.
Manuals are available for downloading from our website www.directhealthcaregroup.com
4
The straps are secured through the holes on the sides of the
stretcher at the position of the patient's hips and shoulders.
Simply pull a strap through each hole, and then loop it through
itself.
Two straps are mounted on each side of the stretcher, and then
hooked to the slingbar. Adjust the slingbar to the appropriate
width to prevent discomfort to the patient.
Before lifting, balance the stretcher using the six alternative lift
loops.
Start lifting carefully, and then stop to ensure that the stretcher is
properly balanced in a horizontal position. If it is balanced,
continue lifting; if not, lower the lift and adjust the balance using
the lift loops.
In each lifting situation, always perform an individual test to ensure
that the lift is properly balanced.
Always make certain that the stretcher is horizontal!
Always use the safety belts according to the instruction
guide for the Ferno Scoop Stretcher!
Before lifting:
Read and follow the instructions for the Ferno Scoop Stretcher.
Plan the lift and decide how many caregivers will be needed to
assist to ensure safety.
Never lift higher than necessary.
B
Do not leave the patient unattended during a lifting situation.
A
Do not use rinsing agent. To en-
sure maximum material life, hang
dry or tumble dry on low heat.
I F U