Mounting The Camera To The Ceiling - JVC TK-C205 Mode D'emploi

Mounting the Camera to the Ceiling

1.
2.
3.
4.
To the ceiling
slab, etc.
5.
6.
Drop Video
prevention signal
wire cable
8.
LABEL
TURN
PULL
Cable extraction hole
4 inch square
electrical box
Power supply cable
7.
Solder or
caulk
Insulation tape
1.
Remove the dome cover
Hold the bottom of the unit and turn the
dome cover counterclockwise.
2.
Pull the label part downwards and
remove the dome cover.
3.
Open a hole of ø140mm in the ceiling.
MEMO
There is no need to open a hole in the ceiling
when extracting the cables from the cable
extraction hole on the camera side.
( See page 8)
4.
Mount the electrical box.
This unit can be mounted with a 4 inch
square electrical box. For mounting an
electrical box, consult your dealer of pur-
chase.
5.
Mount the drop prevention wire.
In order to prevent the unit from falling
for any reason, connect the drop pre-
vention wire to the ceiling slab, etc.
6.
Pull out the cables from the ceiling.
Before connecting, pull out the power
supply and video signal cables about
10cm from the electrical box.
7.
Connect the power supply cable.
When installing, cover the cable with in-
sulation tape so that it does not become
damaged from contact with surrounding
parts.
In addition, be sure to use a wiring
cable for the power supply cable.
8.
Connect the video signal cable
(BNC connector).
E-11