point, both channels are live.
master level control
34
adjust the master level output
mid range control for CH2
35
adjust the mid volume for CH2
low range control for CH2
36
adjust the low volume for CH2
high range control for CH2
37
Adjust the high volume for CH2
jog wheel
a) When search indicator is lit: search function.
During play mode, turn for quick search. Scan in the forward direction when the jog is turned
clockwise, in the reverse direction when the jog is turned counter clockwise. Scanning speed
increases when the jog wheel is turned faster.
38
b) When search indicator is off: pitch bend or frame function.
In pause mode, turn the jog wheel to move the starting point by the number of clicks.
Clockwise moves the point forward, counter clockwise moves the point backwards.
In play mode, turn the jog wheel clockwise to increase and counter clockwise to decrease the
pitch.
display
39
Liquid Crystal Display.
pitch fader
40
Use this fader to increase or decrease the speed of the track.
disc draw
Open the draw with the open/close button [3] and insert a disc with track side facing down.
41
Press the open/close button [3] again to close the draw.
power switch
42
Turn the mixer on or off.
headphone jack
43
Plug a headphone plug into this jack for audio monitoring.
1 MIC INPUT: 6.35mm microphone input
2 DJ MIC INPUT: XLR type microphone input
3 AUDIO OUTPUT: audio output signal connectors (XLR, balanced)
INPUT SWITCH PHONO2/LINE2: switch to PHONO2 to enable the RIAA phono pre-amplifiers
4
on the line inputs [Rear 5]. Switch to LINE2 for all other devices.
5 LINE2: Line 2 input jacks.
6 LINE 1: Line 1 input jacks.
INPUT SWITCH PHONO1/LINE1: switch to PHONO1 to enable the RIAA phono pre-amplifiers
7
on the line inputs [Rear 6]. Switch to LINE1 for all other devices.
8 REC OUTPUT: Record outputs (unbalanced).
9 AMP OUTPUT: Amplifier outputs (unbalanced).
10 POWER SUPPLY INPUT: connect to 230VAC/50Hz power source
29/01/2009
VDSCDM1
Front panel
Rear panel
7
© 2008 Velleman Components nv