Model Description B - Trotec TTK 650 S-EH Mode D'emploi

02. Important ! Please Read First !
The TTK 650 S-EH condensate dryer was designed and manufactured in line
with the latest technological advancements and complies with the require-
ments as laid down in existing European and national guidelines. Conformity
has been certified. The relevant declarations and documents are in the manu-
facturer's possession.
As the user you must read and adhere to the following safety instructions in
order to ensure that this condition is maintained and that no danger results
from the use of this device !
• These operating instructions are a part of the unit and must be kept in close
proximity to either the unit itself or the place where the unit is located.
• Please read these operating instructions carefully before you operate the
unit. The following information must be observed at all times.
• Always make sure that national health and safety guidelines are
adhered to when the unit is in operation.
• This product was subjected to stringent material and function tests
and extensive quality checks before it left our premises.
We must, however, point out that using this device can constitute a hazard
when used by people who have not been instructed in its proper use or
when used for purposes other than those for which it was intended !
The following safety instructions must be observed at all times.
Safety Instructions
• The unit may NOT be used in rooms with acetone,
undiluted acids or solvents.
• Do NOT install or use this unit in rooms where there is a risk of explosion.
• The unit may NOT be installed or used in oil, petrol, sulphur,
chlorine or saline atmospheres.
• The unit may only be used in an upright position and placed on
a flat and level surface.
• Do NOT clean with a hose and or spray with water.
• Please ensure that the air intake and outlet ducts are not obstructed
and free of foreign objects.
• The air intake side must always be free of dirt or any loose objects.
• Do NOT put or force any objects into the unit.
• Do NOT cover or transport while in operation.
• All electric cables outside the unit must be protected against damage
(e.g. by animals).
• Any extensions of the power cable must be selected in compliance
with the unit's connected load, the length of cable allowed and
the purpose for which it is intended.
• Do NOT use for any other purpose other than those purposes described
in these operating instructions. The warranty expires with immediate
effect in case of any breach or non-observance of these terms.
In such cases, we will not be held liable for any action.
Any work that has to be carried out on the refrigerant unit
or the electrical circuits may only be performed by an
authorised and certified specialist dealer !
EN
03. Intended Purpose and Use
This unit has been designed and developed to dehumidify the ambient air.
The unit's specific design and functions make it ideal for drying and dehumidifi-
cation in industrial and commercial scenarios.
Standard Scope of Delivery
• TTK 650 S-EH dehumidifier
• air filter
• discharge hose
• user's manual
Optionally Available Accessories
• condensate pump set
04. Model Description
This unit has been designed for non-stop automatic dehumidification. Its com-
pact form makes it easy to transport and easy to install.
The unit is equipped with a hermetically-sealed refrigerant system, a low-noise,
maintenance-free fan, a hygrostat, an operational hours counter, a power con-
sumption clock, a mains switch and a cable with a mains plug.
The unit operates according to the condensation principle (see figure A). The
humid room air is drawn in by the fan and conducted over the evaporator and
the condensator behind it. The heat is withdrawn from the room air when it
comes into contact with the cold evaporator. The room air is cooled off until it is
below the dew point and the water vapour contained in the air settles on the
evaporator fins as either condensate, frost of ice. The condensate is conducted
away from the unit via the water discharge system.
The dehumidified, cooled air is heated up again at the condensator (heat ex-
changer) and blown out into the room by the fan.
The conditioned, drier air is then mixed with the air that is already in the room.
Because the air in the room is circulated throughout the entire process, the rel-
ative humidity in the room in which the dehumidifier has been installed is con-
stantly reduced.
05. Installation
The following instructions (see fig. B) must be observed in order to ensure that
the unit is operated as safely, economically and as efficiently as possible.
• The unit must be placed on a flat and level surface so that the condensate
can run off without being impeded.
• Place the unit as close to the middle of the room as possible.
This ensures optimum air circulation.
• Maintain a minimum distance of 50 cm to all walls.
• When more than one unit is installed, ensure that the room space is
divided up equally between each of the separate units.
• Please ensure that the air can be drawn into the front of the unit and
that neither the air intake nor the air outlet duct is obstructed.
• Place the unit away from radiators and keep away from other heat sources.
• Please ensure that the room that you wish to dry or dehumidify is sealed off
from the surrounding environment as effectively as possible.
• Please make sure that all doors and windows are closed.
Avoid opening and closing doors.
Operating Instructions Dehumidifier TTK 650 S-EH
B 2