BTI ST 160 E Notice Originale page 29

Action
Orbital Action Settings
Adjusting the stroke rate
preselection
Switching the Power Tool
On/Off
Guide the power tool toward
the workpiece only when
switched on
Switching the worklight
On/Off
Lubrication when cutting
metal
Plunge Cutting
Maintenance and Cleaning
 For safe and proper working, always keep the
machine and the ventilation slots as well as
the tool holder clean.
If the replacement of the supply cord is necessary,
this has to be done by BTI or an authorized BTI ser-
vice agent in order to avoid a safety hazard.
Clean the saw blade holder regularly. For this, re-
move the saw blade from the machine and lightly
tap out the machine on a level surface.
Regularly spray penetrating oil onto the saw blade
holder (see figure 16, page 116).
Check the guide roller regularly. If worn, it must be
replaced through an authorised BTI after-sales ser-
vice agent.
Lubricate the guide roller occasionally with a drop
of oil (see figure 17, page 117).
After-sales Service and
Application Service
In all correspondence and spare parts orders,
please always include the 7-digit order number
given on the nameplate of the machine.
1 609 92A 0CD • 4.11.13
Figure Please observe
8
9
10
11
12
13
14
Disposal
The machine, accessories and packaging should
be sorted for environmental-friendly recycling.
Do not dispose of power tools into household
waste!
Only for EC countries:
According to the European Guide-
line 2012/19/EU for Waste Electrical
and Electronic Equipment and its
implementation into national right,
power tools that are no longer usa-
ble must be collected separately and
disposed of in an environmentally
correct manner.
Subject to change without notice.
Page
113
114
114
114
115
115
115 – 116
English | 29