BTI Befestigungstechnik GmbH & Co. KG
D-74653 Ingelfingen
Ingelfingen, 25.10.2013
Noise/Vibration Information
The measured values of the machine are listed in
the table on page 108.
Noise and vibrational values (vector sum of three
directions) determined according to EN 60745.
The vibration level given in this information sheet
has been measured in accordance with a standard-
ised test given in EN 60745 and may be used to
compare one tool with another. It may be used for
a preliminary assessment of exposure.
Mounting and Operation
The following table indicates the action objectives for mounting and operation of the power tool. The
instructions for each action objective are shown aside. Depending on the type of application, various
instruction combinations are required. Observe the safety instructions.
Action
Inserting the Saw Blade
Ejecting the Saw Blade
Switching on the sawdust
blower device
Connecting the dust
extraction
Adjusting the Cutting Angle
Mounting the metal overshoe
Mounting the splinter guard
28 | English
The declared vibration emission level represents
the main applications of the tool. However if the
tool is used for different applications, with different
accessories or insertion tools or is poorly main-
tained, the vibration emission may differ. This may
significantly increase the exposure level over the
total working period.
An estimation of the level of exposure to vibration
should also take into account the times when the
tool is switched off or when it is running but not ac-
tually doing the job. This may significantly reduce
the exposure level over the total working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
maintain the tool and the accessories, keep the
hands warm, organisation of work patterns.
Figure
Please observe
1
2
3
4
5
6
7
Page
109
109
109
110 – 111
111 – 112
112
113
1 609 92A 0CD • 4.11.13