LaserLiner AutoCross-Laser 3C Mode D'emploi page 9

Completely read through the operating instructions, the „Warranty and
Additional Information" booklet as well as the latest information under
!
the internet link at the end of these instructions. Follow the instructions
they contain.This document must be kept in a safe place and if the laser
device is passed on, this document must be passed on with it.
Function / Application
Cross-line laser vertical and horizontal alignment
– The pivoted housing can be turned with a vernier adjustment
mechanism to permit exact positioning of laser lines.
– Adjustable feet with removable rubber caps
– Automatic levelling range 2.5°, accuracy 0,2 mm / m
– A simple, precise plumb function is afforded by the additional
plumb laser at the bottom and the laser cross at the top.
– The vertical lines are aligned at right angles to one another.
General safety instructions
– The device must only be used in accordance with its intendedpurpose
and within the scope of the specifications.
– The measuring tools and accessories are not toys.
Keep out of reach of children.
– Modifications or changes to the device are not permitted, this will
otherwise invalidate the approval and safety specifications.
– Do not expose the device to mechanical stress, extreme temperatures,
moisture or significant vibration.
Safety instructions
Using class 2 lasers
– Attention: Do not look into the direct or reflected beam.
– Do not point the laser beam towards persons.
– If a person's eyes are exposed to class 2 laser radiation, they should shut
their eyes and immediately move away from the beam.
Laser radiation!
Do not stare into the beam!
Class 2 laser
< 1 mW · 635 / 650 nm
EN 60825-1:2014
AutoCross-Laser 3C
09
EN