Télécharger Imprimer la page

BS BATTERY BS 60 Instructions De Montage page 3

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 4
FIRST CHARGE
In order to optimize the life and power of your battery, an initial charge is highly recommended.
Charge the battery with a Motorcycle battery charger that suits for this size/type of battery with an output current 1/10th
of the battery's rated capacity.
Let the battery settle for 1 or 2 hours after charging before checking the voltage.
If the voltage is less than 12.8 volts, additional charging is necessary.
If the electrolyte level is found fallen has dropped after charging, fill with distilled water up to the "upper level".
After charging replace the vents plugs firmly, wash off acid spillage with water, and dry the battery.
INSTALLATION
Fasten the battery firmly to vehicle. Be sure not to wrongly connect battery's positive and negative terminals.
Do not fold or crimp the battery's exhaust tube.
It may cause explosion if the tube is crimped
MAINTENANCE SERVICE
Check electrolyte level once a month.
Add distilled water to restore the level.
Never use electrolyte to restore the level.
Keep the battery always clean.
Apply grease around the terminals to prevent corrosion.
Keep the exhaust tube free of folds and obstructions.
RECHARGING
Recharging is necessary when you find out that the lights get dim, the horn get weak and/or when you keep the battery
unused during more than one month.
Charge the battery with an output current of 1/10th of the battery's rated capacity.
Charge until the battery starts gassing freely and the specific gravity of electrolyte rises to higher than 1,270.
NOTE
Many batteries contain a special chemical component that has been added to reduce sulfate crystal deposits (which eventually
prevents the battery from accepting a charge).
It is a white chemical powder that may be visible before the battery is activated, but it dissolves once the electrolyte is added.
After charging the battery, the specific gravity of electrolyte rises to 1,290 (at 20°C/86°F).
If the battery has not been used for a quite long time, extended recharging time is required.
INSTRUCTIONS DE MONTAGE, REMPLISSAGE
FR
ET CHARGE D'UNE BATTERIE MOTO
AVERTISSEMENT
Lire attentivement la notice avant d'utiliser votre batterie.
La marque ne peut être tenu responsable des conséquences liées à une mauvaise installation et/ou utilisation de
la batterie sur votre véhicule. Si vous deviez rencontrer le moindre souci, ou avoir un quelconque doute, pour votre
sécurité, nous vous conseillons de faire appel à un professionnel.
Instructions pour une utilisation en toute sécurité.
Porter des lunettes de protection.
Tenir les enfants hors de portée de l'acide des batteries.
Risque d'explosion :
- Un mélange hautement explosif de gaz oxhydrique peut se former lors de la charge des batteries.
Feux, étincelles, flammes et fumer sont interdits :
- Eviter de causer des étincelles lors de la manipulation des câbles ou autre équipement électrique et protéger des
décharges électrostatiques.
- Eviter les courts-circuits.
| www.bs-battery.com
3

Publicité

loading

Produits Connexes pour BS BATTERY BS 60

Ce manuel est également adapté pour:

Bs 30Bs 15Bs 10