Axis Communications T86 Série Mode D'emploi page 11

AXIS T86 Media Converter Switch Series
1 Multicable jacket
2
Braided shield
3
Ethernet wire foil shield (2x)
11. Connect the network and I/O wires to the internal network connectors (11, 16) and the
I/O connector (9). Open these connectors by pushing down on the slots with a flathead
screwdriver. Insert the wire and then release.
12. Connect the ground and power wires to the power connector (DC output (1).
1
Power connector (DC output)
2
Power wire (red)
3
Power wire (red)
4
Clamp
5
Braided shield coil
6
Ethernet wire shield (2x)
7
Digital I/O wire (blue)
8
Digital I/O wire (yellow)
11
EN