ECOVACS ROBOTICS DEEBOT SLIM DA60 Mode D'emploi page 11

4 Charge DEEBOT SLIM
Place DEEBOT SLIM on the Charging Dock
making sure the Charging Contacts on
DEEBOT SLIM and the Charging Dock Pins
make a connection.
Charge DEEBOT SLIM for at least 12 hours
before the first use.
* AUTO Mode Button blinks when DEEBOT
SLIM is charging. AUTO Mode Button
glows continuously when DEEBOT SLIM
is fully charged.
Remove DEEBOT SLIM's battery if the robot will not be used for a long time. In case of battery
*
leakage, please remove the battery and wipe the battery slot clean while wearing protective gloves.
If battery is fully discharged or not used for a long time, its capacity may decrease and need
*
to be reactivated.
To reactivate the battery: Place the robot on the Charging Dock by hand, remove after
*
charging for 3 minutes; repeat 3 times, then charge normally for 3-5 hours.
DEEBOT SLIM uses a long life battery, and does not require frequent replacement. To
*
replace the battery, contact Customer Service or follow the below instructions:
a. Unscrew the Battery Cover Screws, remove Battery Cover.
b. Remove the battery and disconnect the fasteners.
c. Connect the corresponding positive and negative fasteners on the new battery. Insert
the new battery, reassemble the Battery Cover and screw in the Battery Cover Screws.
5 Attach Cleaning Cloth, if desired
To use DEEBOT SLIM's optional mopping feature, attach the provided Cleaning Cloth.
* When using the optional mopping feature, fold area rug edges under themselves so DEEBOT SLIM
will avoid the rug.
Attach the Cleaning Cloth to the Cleaning
Cloth Plate.
3. Operating and Programming
Insert the Cleaning Cloth Plate tabs into the
Cleaning Cloth Plate Slots on the bottom of
DEEBOT SLIM until you hear a click.
9
EN