Publicité
WELDED
STRIP
FOR WALL UNITS 72" AND HIGHER, YOU MUST INSTALL
A WALL ANCHOR BAR FOR EACH SHELVING SECTION.
*SEE FOR MORE INFORMATION.
NOTE: THE 14 1/2" WALL SECTION IS EITHER
PERFORATED OR PLAIN SOLID METAL.
CHART FOR POSTS VS BACKS
NUMBER OF 14 1/2" WALL AND/OR PLAIN BACK 7 1/4"
REQUIRED FOR DIFFERENT POST HEIGHTS
*NOTE: THE PLAIN BACKS (7 1/4"H) MUST BE
INSTALLED FIRST AT THE BASE
TITLE
I:\dessins\INSTRUCTION\INS-001\INS-001017.idw
WALL UNIT:
108" = 7x 14 1/2"
96" = 6X 14 1/2" + 1X 7 1/4"
90" = 6X 14 1/2"
84" = 5X 14 1/2" + 1X 7 1/4"
80" = 5X 14 1/2"
72" = 4X 14 1/2" + 1X 7 1/4"
66" = 4X 14 1/2"
60" = 4X 14 1/2"
54" = 3X 14 1/2" + 1X 7 1/4"
52" = 3X 14 1/2" + 1X 7 1/4"
48" = 3X 14 1/2"
S RIE HYBRIDE
HYBRID SERIES
STEP 4
PLACE THE END POST IN VERTICAL POSITION AND
BE SURE THE WELDED STRIPS OF THE END POSTS
ARE FACE TO FACE TO BE ABLE TO SLIDE IN FIRST
THE 7 1/4" H METAL BACK FOLLOWED BY THE 14 1/2"
H METAL BACK. ON BOTH THE FRONT AND REAR OF
THE HD POST (UPRIGHT). SEE THE GRID OF CHART
POSTS VS BACKS.
THE HORIZONTAL EDGE OF THE PLAIN AND
PEFORATED BACK PANELS HAVE A CONVEX AND
CONCAVE HORIZONTAL EDGE. MAKE SURE THE
CONCAVE EDGE IS FACING THE BOTTOM WHEN YOU
SLIDE THE PANEL DOWN THE WELDED STRIP.
REPEAT THE SAME PROCESS FOR EACH PANEL TO
ENSURE A TIGHT FIT.
NOTE
CONVEX EDGE
FACING UP
PERFORATED
BACK METAL
14 1/2"
(ITEM#7)
CONCAVE
CONVEX
PLAIN BACK
METAL 7 1/4"H
(ITEM#4)
CONCAVE EDGE
FACING DOWN
METHOD OF
INTERLOCKING
THE BACK PANELS
DRAWING
INS-001017
PAGE
REV
-
17
21
OF
Publicité
