Preparation Only For The Dcs-Fs30 - Pioneer DCS-585 Mode D'emploi

Speaker Setup Guide
Securing your front and surround
speakers
• Secure each of the front and surround
speakers using the plastic catch provided.
Screw two supporting hooks into the wall
behind the speaker. Pass a thick cord around
the hooks and through the plastic catch so that
the speaker is stabilized (make sure to test that
it supports the weight of the speaker). After
installing, make sure the speaker is securely
fixed.
Plastic catch
CAUTION
• The plastic catch is not a mounting fixture,
and the speaker should not be hung
directly from the wall using this catch.
Always use a cord when stabilizing the
speaker.
• Pioneer disclaims all responsibility for any
losses or damage resulting from improper
assembly, installation, insufficient
strength of the installation materials,
misuse, or natural disasters.
• When placing this unit, ensure that it is
firmly secured and avoid areas where it
may be likely to fall and cause injury in the
event of a natural disaster (such as an
earthquake).
Sufficiently thick
cord

Preparation only for the DCS-FS30

Assembling the speaker stands and
securing your front speakers
1 Install the pole with a circular nut
attached onto the speaker stand base, using
the hexagon nuts and washers provided.
Use the spanner provided for installation.
CAUTION
• Be careful that the stand does not fall over
when installing the pole.
2 Lay the speaker stand on its side, and pass
the speaker cables into the hole in the
speaker stand base and through the pole.
01
7
En