LA NORDICA ANTHEA Instructions Pour L'installation, L'utilisation Et L'entretien page 18

The inside smoke plate made of vermiculite, reflects the fire radiation and increases the internal temperature
of the combustion chamber. This process together with the exhaust gases flows, makes optimal the
combustion and improves the efficiency.
The one-piece ceramic glass of the door (resistant up to 700 ° C) allows a wonderful view on the burnin g
flames. Furthermore, it is thus avoided the output of sparks and smoke.
Below the hearth grate there is an extractable ash drawer, (Picture 9 pos. A).
The heating of the environment is made by irradiation: through the panoramic glass and the external hot
surfaces of the stove, the heat is radiated into the environment.
The stove is equipped with controls of primary and secondary air by which it is adjusted the combustion air.
1A - PRIMARY air register (left lever)
Below the hearth door, on the front left side, there is the
primary air register, in the style of lever (Picture 1 - 1A)
With this air register, it is adjusted the passage of primary
air into the low part of the stove and through particular
channels flows in the fuel direction. The primary air is
necessary for the combustion process during lighting. The
ash drawer must be regularly emptied, so that the ash
does not obstruct the entry of the primary air for the
combustion.
In order to open the air flow, the bar must be completely
pulled out,
During wood combustion, the register of primary air must
be opened only for a while, because otherwise the wood
burns too fast and the stove may overheat. (see
paragraph 10).
2A - SECONDARY air register (right lever)
Below the hearth door, on the right front side there is the
secondary air register (Picture 1 - 2A).
The secondary air, passing through the two lateral jambs of the front side, heats itself starting the double
combustion and keeping at the same time the glass clean (with open register).
When the bar is pushed to the back the passage of the secondary is completely open (Picture 1 - 2A).
3. RULES FOR INSTALLATION
The stove, assembled and ready for the installation, must be connected with a junction to the existing flue of
the house. The junction must be possibly short, straight, horizontal or positioned a little uphill. The connections
must be tight.
It is obligatory to respect the National and European rules, local regulations concerning building
matter and also fireproof rules. Please apply to your chimney sweeper for all information.
You should verify the sufficient air entrance for the combustion in the installation place, with particular attention
to windows and doors with tight closing (seal ropes).
It is not allowed the connection of various appliances to the same chimney. The diameter of the opening for
the connection must correspond at least to the diameter of the smokes pipe. The opening should be equipped
with a wall connection for the reception of the exhaust pipe and a rose window.
Before installation, verify if your floor can support the weight of the stove (for ex. distributing weight plate).
LA NORDICA is not responsible in case of modification of the product and for the use of not original
spare parts. The hearths must not be modified.
THE HEARTHS MUST NOT BE MODIFIED.
18
ANTHEA – VENERE
Picture 1
7194201 Rev.06 – EN