Initial Operation Of The Unit - uebe cyclotest baby Mode D'emploi

Operating the unit

Initial operation of the unit

Press the small round Start button during initial operation to start the
cycle and to start each subsequent new series of cycle measurements.
You enter the start of the cycle with the Start button. This should be
done if possible on the first day of your menstruation. Press the Start
button firmly and hold down until the input is confirmed with a beep.
You can enter the start of the cycle independently of a measurement,
i.e. also in the afternoon or the evening.
In this case, wait until the unit has switched itself off and then repeat
the input. Important: press the Cycle Start button firmly and for a sus-
tained period.
Note: cyclotest® baby cannot store any measurement results if the
start has not been input.
Fig. no. 1
Your display looks like this if the input has
been successful.
Fig. no. 2
If your display looks like this, the input has
not been made.
EN-50