Angelo Po 191PI2E Manuel D'utilisation Et D'installation page 33

SWITCHING THE APPLIANCE ON AND OFF
Lighting
1 - Turn on the appliance's circuit breaker to con-
nect it to the electrical mains.
2 - Turn the knob (A) clockwise (pos. 1) to the tem-
perature required to turn on the heating ele-
ments.
The mains light (B) comes on.
3 - Turn the knob (A) gradually anti-clockwise to
regulate the power of the heating elements
down to the minimum setting (pos. 2).
Turning off
1 - Turn the knob (A) anti-clockwise (pos. 3) to turn
off the heating elements.
2 - Turn off the appliance's circuit breaker to dis-
connect it from the electrical mains.
FILLING THE PAN
To carry out this operation, proceed as follows.
1 - Raise the lid (A).
2 - Turn the water spout (B) towards the pan.
3 - Turn on the water taps (C) to fill the pan to a lev-
el between the two marks (D).
Important
For faster boiling times, use hot water only;
use cold water only when specifically re-
quired.
4 - Turn the water spout outward and then close
the lid (A) and tighten the clamps (E).
Caution - warning
Never use the appliance with no water in the
well, as this may damage its structure.
5 - To drain the pan turn on the tap (F).
Caution - warning
Before draining the pan or opening the lid (A),
press the button (G) to discharge the remain-
ing steam (For version 191PI2EA only).
B
D
A
C
F
- 9 -
A
1
2
3
IDM-39616400700.tif
G
E
IDM-39616400800.tif
D
IT
GB
DE
FR
ES
English